Home About us Editorial board Ahead of print Current issue Search Archives Submit article Instructions Subscribe Contacts Login 
  • Users Online: 1417
  • Home
  • Print this page
  • Email this page
ORIGINAL ARTICLE
Year : 2019  |  Volume : 16  |  Issue : 5  |  Page : 318-326

Effect of heat treatment and addition of 4-META to silane on microtensile bond strength of IPS e.max CAD ceramic to resin cement


1 Oral Health Research Center, Department of Esthetic and Restorative Dentistry, Health Research Institute, Babol University of Medical Sciences, Babol, Iran
2 Dental Materials Research Center, Department of Esthetic and Restorative Dentistry, Institute of Health, Babol University of Medical Sciences, Babol, Iran
3 Department of Dental Biomaterials, School of Dentistry, Shahid Beheshti University of Medical Sciences, Tehran, Iran

Correspondence Address:
Dr. Behnaz Esmaeili
Department of Esthetic and Restorative Dentistry, School of Dentistry, Babol University of Medical Sciences, Babol
Iran
Login to access the Email id

Source of Support: None, Conflict of Interest: None


DOI: 10.4103/1735-3327.266086

Rights and Permissions

Background: Silane promotes bonding between ceramic and resin cement. Silane function could be improved by heat treatment and adding 4-Methacryloxyethyl trimellitate anhydride (4-META). The aim of this study was to assess the effect of heat treatment and adding 4-META to silanes on the microtensile bond strength of IPS e.max CAD ceramic and resin cement. Materials and Methods: In this in vitro study, 32 IPS e.max CAD blocks (6 mm × 6 mm × 4 mm) were randomly divided into 8 groups of 4. The ceramic surfaces were etched by 10% hydrofluoric (HF) for 20 s, and Clearfil Ceramic Primer Plus, Clearfil Porcelain Bond Activator (CPA) +4-META, CPA + Clearfil SE Bond (CPA + SE), and Bis-Silane with and without Oven drying at 100°C for 5 min were applied on the ceramic surfaces as silanes, and then, the ceramics were bonded to composite disks by dual-cured resin cements. Ultimately, a total of 120 sticks ( 1 mm × 1 mm × 8 mm) were subjected to microtensile bond strength test (15 sticks from each group) and the failure types were assessed by stereomicroscope at 40x. Data were analyzed by two-sided analysis of variance test and Student's t-test the P values were considered to be < 0.05. Results: The Bis Silane group (two bottles) showed maximum bond strength (P = 0.009). Heat treatment significantly reduced the bond strength in Bis Silane (P = 0.0001); but, in other groups, it did not show significant effect on the bond strength. Adding 4-META to CPA did not significantly affect the microtensile bond strength of IPS e.max CAD ceramic to resin cement, and there was no difference in mode of failure between groups. Conclusion: The effect of silane type was significant on the microtensile bond strength of the ceramic to resin cement. The effect of 4-META on the bond strength was not significant. The interaction between silane type and heat treatment on the bond strength of ceramic to resin cement was also significant.


[FULL TEXT] [PDF]*
Print this article     Email this article
 Next article
 Previous article
 Table of Contents

 Similar in PUBMED
   Search Pubmed for
   Search in Google Scholar for
 Related articles
 Citation Manager
 Access Statistics
 Reader Comments
 Email Alert *
 Add to My List *
 * Requires registration (Free)
 

 Article Access Statistics
    Viewed31    
    Printed0    
    Emailed0    
    PDF Downloaded8    
    Comments [Add]    

Recommend this journal